Electrolux 625 (0505) Rev. B ENTIRE COOKTOP DOES NOT OPERATE, SURFACE ELEMENT DOES NOT HEAT

Solutions to Common Problems

ENTIRE COOKTOP DOES NOT OPERATE

•House fuse has blown or circuit breaker has tripped. Check/reset breaker or replace

fuse. If the problem is a circuit overload, have this situation corrected by a qualified

electrician.

•Service wiring not complete. Contact installation agent or dealer.

•Power outage. Check house lights to be sure. Call local electric company.

SURFACE ELEMENT DOES NOT HEAT

•No power to appliance. Check/reset breaker or replace fuse. If the problem is a circuit

overload, or improper connection of the armored cable supplied with the appliance, have

this situation corrected by a qualified electrician.

•Too low heat setting. Turn control to a slightly higher setting until element comes on.

•Incorrect control is ON. Be sure to use correct control for the element needed.

•Incorrect control setting. Raise or lower setting until proper amount of heat is obtained.

Dial markings are an indicator of relative heat settings and will vary slightly.

•Lightweight or warped pans being used. Use only flat, evenly balanced, medium or

heavyweight cookware.

•Voltage is incorrect. Be sure appliance is properly connected to the specified power

source.

•Use only flat bottom, evenly balanced, medium or heavyweight cookware. Pans having a

flat bottom heat better than warped pans. Cookware material affects heating. Heavy and

medium weight pans heat evenly. Because lightweight pans heat unevenly, foods may

burn easily.

Before calling for service, review the following problems first. It may save you both time

and expense. This list includes common experiences that are not the result of defective

workmanship or material in your cooktop.