Electrolux 75438 KG user manual Prior to Initial Start-Up

Prior to Initial Start-Up

Before connecting the appliance to the mains and putting it into ope-ration for the first time, leave the appliance to stand for 30 minutes if was tran- sported upright. After transport on its side, the appliance must be left to stand for 2 hours before putting it into operation. This is necessary to allow the oil to flow back into the compressor. Otherwise the compressor may be damaged.

1.Please clean the appliance interior and all accessories prior to initial start- up (see section: "Maintenance and Cleaning").

2.The appliance must be correctly installed in accordance with the chapter

"Installation" before it is put into operation for the first time. Care should be especially taken that the mains voltage and frequency available corre- spond with the appliance’s rating plate.

3.Remove the cold accumulation block from the appliance.

4.Place the cold accumulation block into a drawer only after the optimal storage temperature of -18 °C has been reached, and allow to freeze.

5.After 24 hours place the cold accumulation block at the front of the upper drawer.

6.Re-freeze the thawed cold accumulation block in the same fashion, e.g. after cleaning the appliance.

Initial Start-Up

1.Insert plug into mains socket.

2.The temperature indicator and the back lighting light up, the appliance starts up. An alarm sounds, TEMPERATURE appears in the display and the back lighting flashes in red.

3.Switch off alarm and red back lighting using RESET button. The TEMPE- RATURE indicator goes out, if the temperature in the appliance has gone below the warning temperature.

3 Temperature settings set in the factory: +5 °C for the fridge section, -18 °C for the freezer section.

4.Set the refrigerator to the desired temperature (see section: "Tempera- ture Adjustment").

Goods to be refrigerated can be loaded shortly after switching on, because the storage temperature in the refrigerator is quickly reached.

10