quences for the environment and human health, which could other- wise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
Remove transport packaging
The appliance and the interior fittings are protected for transport. ☞1. Pull off the adhesive tape on the left and right side of the door.
2.Remove all adhesive tape and packing pieces from the interior of the appliance.
Installation
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use and efficient performance of the appliance is affected by the ambient temperature.
The appliance should therefore
–not be exposed to direct sunlight;
–not be installed next to radiators, cookers or other sources of heat;
–only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed.
The climate classification can be found on the serial plate, which is located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for each climate classification:
Climate classification |
| for an ambient temperature of |
|
|
|
|
|
|
SN |
| +10 to +32 °C |
|
|
|
|
|
|
N |
| +16 to +32 °C |
|
|
|
|
|
|
ST |
| +18 to +38 °C |
|
|
|
|
|
|
T |
| +18 to +43 °C |
|
|
|
If the refrigeration appliance is installed next to another refrigerator or freezer a clearance of 5 cm at the sides is required, in order to pre- vent the formation of condensation on the outside of the appliance.
7