Electrolux AW 1402 W Operating sequence, Load the laundry Open the door by carefully pulling the

Models: AW 1402 W

1 28
Download 28 pages 38.12 Kb
Page 14
Image 14
Operating sequence

Operating sequence

Load the laundry Open the door by carefully pulling the

door handle outwards.

Place the laundry in

the drum, one item at

a time, shaking them out as much as

possible. Close the door.

Measure out the detergent and the fabric softener

Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment Load the laundry Open the door by carefully pulling the and, if you wish to carry out a programme with the prewash, pour it into the compartment marked Measure out the detergent and the fabric softener .

If required, pour fabric softener into the compartment marked Select the required programme by means of the programme selector dial (1) (the amount used must not exceed the «MAX» mark in the drawer). Close the drawer gently.

Select the required programme by means of the programme selector dial (1)

Turn the programme selector dial to the required programme.

The green light of button 6 starts to flash. It can be turned either clockwise or anticlockwise.

On position «O» the programme is reset and the machine is switched OFF.

At the end of the programme the selector dial must be turned to position «O», to switch the machine off.

Select the spin speed or Rinse Hold option by pressing button 3 ATTENTION!

If you turn the programme selector dial to another programme when the machine is working, the red pilot light of button 6 will flash 3 times to indicate a wrong selection. The machine will not perform the new selected programme.

Select the required temperature by means of the temperature selector dial (2)

Turn the programme selector dial to the required temperature. It is possible to select a temperature from 90°C to Cold.

For the maximum temperature allowed by each programme, refer to the section «Programmes table».

Select the spin speed or Rinse Hold option by pressing button 3

The relevant light will light up.

When selecting a programme, the light corresponding to the maximum speed allowed for that programme will illuminate (refer to the section «Programme table»).

Select the desired option by means of buttons 4 and 5

Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before pressing the button 6.

For the compatibility of the options with the washing programmes, refer to the section

«Programme table».

14

Page 14
Image 14
Electrolux AW 1402 W Operating sequence, Load the laundry Open the door by carefully pulling the, «Programme table»