Electrolux C65301KF-n 1 , 3

Operating Instructions

The four display fields correspond to the four cooking zones, and give

the following indications:

–”-“, when switched on, and when switched off automatically by the

safety function,

–”0.“, when a cooking zone is selected,

–”v“, when the Keep Warm setting is selected,

–”1.“ to “9.“, depending on the selected Cook setting,

–”A“ ,when Automatic Warm Up is on,

–”H“, when Residual Heat is on,

–”F“, if there is a fault.

1 Cooking Zone Safety Cut-out

If one of the cooking zones is not switched off after a certain time or if

the heat setting is not changed, the corresponding cooking zone

switches itself off automatically.

h appears in the ring display for all rings that were switched on, and

j after they have cooled down.

The rings are switched off at:

3 If one or more cooking zones switch off before the times indicated see

section “What to do if …”.

To cancel the activated safety cut-out the appliance must be switched

off and then on again using the ON/OFF n sensor field. After this the

cooking zones are again ready for use.

Liquids that boil over onto the control panel cause all cooking zones to

switch off immediately.

If you place a wet cloth on the control panel it has the same effect. In

both cases the appliance has to be switched on again using the mains

switch n after removing the liquid or cloth.

•Heat setting 1 - 2 after 6 hours

•Heat setting 3 - 4 after 5 hours

•Heat setting 5 after 4 hours

•Heat setting 6 - 9 after 1.5 hours