Electrolux CycloneXL manual Getting the best results, Using the turbo nozzle

19 20

21 22

23 24

25 26

Getting the best results

Use the nozzles as follows:

Carpets: Use the combination floor nozzle with the lever in position (19).

Hard floors: Use the combination floor nozzle with the lever in position (20).

Wooden floors: Use the parquet nozzle* (21).

Upholstered furniture and fabrics: Use the upholstery nozzle* (22) for sofas, curtains, lightweight fabrics etc. Reduce suction power if necessary.

Frames, bookshelves, etc.: Use the feather duster* (23).

Crevices, corners, etc.: Use the crevice nozzle* (24).

Using the turbo nozzle*

25/26 Ideal for carpets and wall-to-wall carpeting to remove stubborn fluff and pet hairs.

Note: Do not use the turbo nozzle on skin rugs or carpet fringes. To avoid damaging the carpet, do not keep the nozzle stationary whilst the brush is rotating. Do not pass the nozzle across electric cables, and be sure to switch off the vacuum cleaner immediately after use.

* Certain models only.

Emptying and cleaning the dust container

CycloneXL’s dust container must be emptied when it is full.

27Pull the release button at the rear of the vacuum cleaner.

28Lift the dust container out.

29Open the lid of the dust container by pressing the release button on the right.

30Empty it over a wastepaper basket. Put the dust container back (31) and press the rear part of the container until it clicks into place.

32Every now and then the dust container should be cleaned. Remove lids at both ends and rinse the container in water or machinewash it. Remove particles that may be stuck in the cone.

* Certain models only

27

28

29

30

31

32