14Installation

INSTALLING THE BURNER COMPONENTS

!WARNING

Never attempt to operate the cooktop with any of the burner rings, burner caps, grates or grill components removed.

Burner Components

Remove the brass burner rings, porcelain burner caps, and porcelain grates from their shipping packages. Place each burner ring onto its corresponding burner base, being certain that the five alignment tabs slide into the matching notches in the base. Set each porcelain burner cap on top of its corresponding burner ring. Place each grate onto the cooktop, being certain that the rubber feet are positioned in the locating dimples.

Figure 7

Grate

Burner Cap

Burner Ring

Top Frame

Burner Head (Fixed)

Burner Components

NOTE

Grill Components

Remove the grill components from inside the main carton. Remove all of the packing materials from the Grill, U-burner, Heat Control Channels, Grease Control Box and the Drip Pans.

Begin your set up by placing the Drip Pans inside on the bottom of the open grill burner box area, using the dimples to locate the Drip Pan. Next, slip the open end of the U-burner onto the gas stub located in the front inside of the grill burner box, and insert the bracket on to opposite end of the U- burner into the slot located on the Grease Control Box. Proceed to install the Heat Control Channels, which sit on top of four pins at the inside front and back of the grease control box. Finally, set the grill in place on the top of the cooktop.

The U-burner is adjusted at the factory and does not require any field adjustment for proper function.