Electrolux E30IC80ISS Electric Cooktop Installation Over 30Electric Single Wall Oven, E30EW75GSS

Electric Cooktop Installation

Over 30"Electric Single Wall Oven

For all approved electric cooktop models, cut minimum 4" x 4" opening in right cabinet side panel and/or filler panel, to route armoured cable to junction box

Side filler panels necessary to isolate oven from
adjoining cabinets. Panel height may need to
be modified to accommodate the depth of approved	240/208V
electric cooktop models
	Junction box
Electric Single Wall Oven Cutout	for electric
	cooktop
For models: E30EW75GPS
& E30EW75GSS
Cooktop	Approx. 3"
cutout**
	Oven cutout
	36"
	min.
Approx. 3"	28 1/2" min.
24"min.*	28 7/8" max.
240/208V
Junction box	28 1/2"min.
for wall oven	29"max.
24" min.	Install 3/4" full plywood base on 2 runners, flush
cutout depth	with toe plate, capable of supporting 200 lbs.

Unit will overlap cutout (minimum) edges by 1"

4-1/2" maximum height allowed from oven base to floor if cooktop is installed directly over wall oven. (5" maximum height allowed with no cooktop.)

To route armored cable to junction box through left cabinet side panel and/or filler panel, cut minimum 4" x 4" opening in wood base and runner

*Critical dimension – MUST be applied **For cooktop cutout dimensions refer to model-specific product page or installation guide on web

30" Electric Single Wall Oven Under-Counter Installation Specifications

•Product Weights – (E30EW75GPS) 178 Lbs. / (E30EW75GSS) 175 Lbs.

•Single phase 3- or 4-wire cable, 120/240 or 120/208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line.

•Connected Load (kW Rating) @ 240/208 Volts = 4.0/3.0kW

•Amps @ 240/208 Volts =16.6/14.4 Amps

•Always consult local and national electric codes.

•Minimum 23-1/4" clearance for oven door depth when open.

•Minimum 24" deep cutout dimension is critical for proper installation, to ensure that oven’s faceplate will fit flush against cabinet front.

•Full oven base of solid plywood or similar material required, capable

of supporting 200 Lbs. Install over two runners and flush with toe plate.

•Base must be level and cabinet front must be square with finish-cut bottom edge.

•Side filler panels necessary to isolate oven from adjoining cabinets.

•Allow 5" maximum height from oven base to floor, if NO cooktop is installed directly over wall oven.

Electric Cooktop Installation Over

30" Electric Single Wall Oven Specifications

Electrolux ICON® Single Wall Oven models E30EW75GPS and E30EW75GSS are approved to be used beneath Electrolux ICON® electric cooktop models E36IC75FSS, E30IC75FSS, E36IC80ISS, E30IC80ISS, E36EC70FSS and E30EC70FSS (electric cooktop models NOT approved for use in this installation are E36EC75HSS, E30EC65ESS and E36EC65ESS).

For detailed Electric Cooktop installation, refer to model-specific product page and installation guide on web.

•Side filler panels necessary to isolate oven from adjoining cabinets. Panel height may need to be modified to accommodate the depth of approved electric cooktop models.

•To route armored cable to junction box, cut minimum 4" x 4" opening in right cabinet side panel.

•Allow 4-1/2" maximum height from oven base to floor, if cooktop is installed directly over wall oven.

Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxicon.com for detailed instructions.

Electrolux Major Appliances, N.A.

USA • 250 Bobby Jones Expressway • Augusta, GA 30907 • 1-877-4electrolux (1-877-435-3287) • electroluxicon.com	High standards of quality at Electrolux Home Products, Inc. mean we are
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxicon.ca	constantly working to improve our products. We reserve the right to change
	specifications or discontinue models without notice.

EC_EW INST 05/09 © 2009 Electrolux Home Products, Inc. Printed in the U.S.A.