Operation 19
WARNING
Do not touch any burner cap, burner base, or igniter while the igniters are sparking, as an electrical shock could result.
IMPORTANT
•If the gas does not ignite within four seconds, turn off the valve. Allow at least two minutes for any gas to dissipate, then repeat the lighting procedure.
•Burner igniters must always be kept clean and dry to function properly. Due to the
•When the cooktop is cool and/or more than two burners are in use, the igniters may continue to spark if the control knob is set to the “LOW” position. This is normal until the burner warms up. The tendency to spark under these conditions can be reduced by operating the burner at a higher flame setting for a short period of time (normally 60 seconds or less), then adjusting the control knob down to the “LOW” setting. The burner will also warm up faster if a utensil is placed on the grate.
•The flame should be steady and blue in color. Foreign material in the gas line, especially in new construction, may cause an ocooktop flame during initial operation. This will disappear with further use.
•The flame should burn evenly around the perimeter of the burner. If the flame is uneven, ensure that the brass burner ring and porcelain burner cap are properly positioned, then check for any foreign material in the burner ring or on the burner cap. Remove any foreign material with a straightened paper clip, wire, or needle. Do not use a toothpick to remove clogs, as it could break off. Do not damage the brass or distort the shape of the burner ring ports.
•Never light the burners with a match or other open flame. If a burner does not ignite, refer to the Troubleshooting Guide.
