Buzzer
When the drying cycle has finished, an inter- mittent audible signal will sound. By depress- ing button the acoustic signal is switched off in the following cases:
•when selecting the programme
•when depressing the buttons
•when the programme selector dial is turned to another position during the pro- gramme or when you depress an option button during the cycle
•at the end of the programme.
The corresponding light comes on.
Time
Use the TIME button to select the pro- gramme duration after setting the TIME pro- gramme. You can select a programme du- ration from 20 min. to 3 hours in
1.Turn the programme selector to the pro- gramme.
2.Press the button repeatedly until the de- sired programme duration is shown in the
display, e.g. | for a pro- |
gramme of 20 minutes. |
|
If the programme duration is not selected, the duration is automatically set to 10 mins.
Delay start
With the DELAY button, you can delay the start of a programme by between 30 minutes (30') and a maximum of 20 hours (20h).
1.Select the programme and additional functions.
2.Press the Delay button as many times as
necessary until the required time of the delay appears on the display, e.g. 
H if the programme is to be started in 12 hours.
If the display is showing 
H and you press the button again, the time de- lay will be cancelled. The display will show 0 and then the duration of the se- lected programme.
3.To activate the delay timer, press the Start/Pause button. The amount of time remaining until the programme is set to start is continuously displayed (e.g. 15h, 14h, 13h, … 30' etc).
electrolux 9
Setting child lock
The child lock can be set to prevent a pro- gramme being accidentally started or a pro- gramme in operation being accidentally changed. The child lock function locks all buttons and the programme knob. The child lock can be activated or deactivated by hold- ing down the BUZZER and TIME buttons si- multaneously for 5 seconds.
– Before programme is started: Appli- ance cannot be used
–After programme is started: Pro- gramme in operation cannot be changed
The 
icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end.
If you want to set a new programme, you must first deactivate the child safety device.
Starting the programme
Press the START / PAUSE button. The pro- gramme is started.
The programme phase is shown in display by appropriate icons. From left to the right, from drying 
,anticrease 
, to cooling 
.
Changing programme
To change a programme which has been se- lected by mistake once the programme has started, first turn the programme selector to
"O" (OFF) position. The programme is can- celled.
The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme knob or if an function button (excluding the button) is pressed, led above START/PAUSE button starts flashing temporarily in yellow. The drying programme is not however affected by this (laundry protection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, display shows a blinking " 0 ", under 
and filter 
icon appear dash. If the (Buzzer)
