electrolux installation 19
•Mark the wall with a centre line, this will aid mounting procedure (1), position the template so that the mid line printed on the template matches with the centre line previously marked, the lower side of the template corresponds to the lower side of the hood once mounted
(2).
•Drill two holes Ø 8mm and fix the support bracket with two wall plugs and screws (3).
•Remove the front panels (see paragraph “Removing the front panels”) and the grease filter.
•Hang the hood (4) adjust its position
•Make electrical connection (10), but leave the hood disconnected from the home mains circuit.
•In the case that it is decided to use the cooker hood in the mains circuit, then place one of the two flanges provided in the exit hole (11 – Extraction). Attention! The tall flange should be used when a telescopic chimney is required to be mounted (this item should be ordered – see special accessories), the short flange is to be used in all other cases.
•Remount the grease filter and the front panels (12a-b-c).
| 4 |
(5x18) |
|
6 | (5x18) |
5 | 6 |
| 5 |
9
10
12a
12b
12c
4GB
3
7
8 8
2
1
Extraction | mode |
11 |
|
11 |
|
Recirculation mode