41
Installation
Fig. 9 - Wall mounting

Mounting accessories included

4 screws 5 x 45 mm
4 wall plugs (brick fixing) Ø 8 mm
4 screws 4,2 x 35 mm
1 flange Ø 125 mm
1 allen spanner (for TORX screws)
1 screw 2.9 x 13

Wall unit mounting

•Make the holes on the bottom of the cupboard
(2), using the drilling template (1).
Make a hole for the exhaust pipe (4) if the hood
is to be used in the extraction version (3).
•From inside the cupboard, insert the 4 supplied
screws (5) and tighten them in the appropriate
holes on the appliance.

Wall mounting

•Mark a centre line on the wall (1).
Fit the template onto the wall (2).
•Fix the drilling template to the wall.
•Make 3 Ø 8mm holes in the wall (3), 2 at upper
points, 1 as desired at lower points.
•Insert the three Ø 8mm expansion plugs into the
wall (4) (brick fixing only)..
•Insert 2 5x45 screws (5) but do not tighten them
completely, hang the hood (6).
•Adjust the unit so that it is positioned at a right
angle to the wall by turning the two screws on
lower side (7).
•Tighten the 2 upper screws (8).
•From inside the hood, insert the third 5x45
screw into the lower hole (9) and tighten (10).
Fig. 8 - Wall unit mounting
2
3
4
4
4
5
5
3
1
6
6
9
8
1cm

5

!

10
8
7
7
1
2
5
4
5
5
5
3