10 electrolux
Hob burners control knobsHob burners control knobs
Hob burners control knobsHob burners control knobs
Hob burners control knobs
The symbols on the knobs mean that :
# there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burnersLighting the burners
Lighting the burnersLighting the burners
Lighting the burners
For easier lighting, proceed beforeFor easier lighting, proceed before
For easier lighting, proceed beforeFor easier lighting, proceed before
For easier lighting, proceed before
putting a pan on the pan support.putting a pan on the pan support.
putting a pan on the pan support.putting a pan on the pan support.
putting a pan on the pan support.
To light a burner:
#push in the relevant control knob and turn
it anticlockwise to maximum position ( ),
to ignite the burner.
#After lighting the flame, keep the knob
pushed down for about 5 seconds. This
will allow the "thermocouple" (Fig. 1 - lett.
D) to be heated and the safety device to be
switched off, otherwise the gas supply
would be interrupted.
#Then adjust the flame as required.
If the burner does not ignite, turn the control
knob to zero, and try again.
When switching on the mains, after
installation or a power cut, it is quite normal
for the spark generator to be activated
automatically.
In the absence of electricity, ignition can
occur without the electrical device; in this
case, approach the burner with a flame,
push the relevant knob down and turn it
anti-clockwise until it reaches the
“maximum” position.
OperationOperation
OperationOperation
Operation
!ACappellotto
Fig. 1
AA
AA
A - Burner cap
BB
BB
B - Burner crown
CC
CC
C - Ignition electrode
DD
DD
D- Thermocouple
A
B
D
C
Triple crown burner