18electrolux
Fitting the Hob into the Worktop
Before fitting the hob into the cut out, an adhesive seal must be fitted to the underside outside edge of the hob. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below.
1)Remove the pan supports, the burners caps and crowns and turn the hob upside down, taking care the ignition candles are not damaged in this operation.
2)Place the sealing gasket (C) all around the glass top edge as shown in diagram A.
3)Place the hob in the cut out, taking care of its centring.
4)Fit the hob in the cut out and push it down until the glass top and the working top make contact, as shown in diagram B.
A |
B |
C |
C)Sealing gasket
