8electrolux

Operation

Hob burners control knobs

The symbols on the knobs mean that :

 

there is no gas supply

 

there is maximum gas supply

 

there is minimum gas supply

 

Lighting the burners

 

 

For easier lighting, proceed before

 

putting a pan on the pan support.

 

To light a burner:

 

 

)z Turn the relevant knob anticlockwise to

A - Burner cap

B - Burner crown

maximum position (

) and push down

C - Ignition electrode

the knob to ignite.

 

 

D - Thermocouple

z After lighting the flame, keep the knob

pushed down for about 5 seconds. This will allow the "thermocouple" (Fig.-lett. D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted.

z Then, check the flame is regular and adjust it as required.

z If the burner does not ignite, turn the control knob to off position, and try again.

z If you cannot light the flame even after several attempts, check the "cap" (Fig.-lett. A) and “crown” (Fig.-lett. B) are in the correct position.

When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.

In the absence of electricity, ignition can occur without the electrical device; in this case, approach the burner with a flame, push the relevant knob down and turn it anti-clockwise until it reaches the “maximum” position.

Do not keep the control knob pressed for more than 15 seconds. If the burner does not light even after 15 seconds, release the control knob, turn it the "off" position ( ) and wait for at least one minute before trying to light the burner again.

Page 8
Image 8
Electrolux EHT 60410 manual Operation, Hob burners control knobs, Lighting the burners