Electrolux EI28BS36IS, EI28BS36IB manual To adjust the flipper mullion

Models: EI28BS36IB EI28BS36IS

1 32
Download 32 pages 55.72 Kb
Page 9
Image 9

Installation 9

4Lift the door while adjusting the washer. To raise the door, rotate washer clockwise (when viewed from the bottom). To lower door, rotate washer counter-clockwise (when viewed from the bottom).

To adjust the flipper mullion:

1Loosen the screw located on the flipper mullion hinge.

Raising/Lowering Door

5Re-tighten the screw, ensuring it is between the spokes of the set washer. Screw will not be tight, just insert until it is flush with the hinge.

Screw

NOTE

If after adjusting doors higher the door makes a popping/clicking sound, remove screw and replace with the longer one supplied in the handle package.

Adjusting Flipper Mullion Screw

2Adjust flipper mullion height. For proper connection with the flipper mullion guide, there should be a separation about the thickness of a coin (0.060 inches, or 1.5 mm) between the guide and flipper mullion.

Adjusting Flipper Mullion Height

3Re-tighten screw.

Page 9
Image 9
Electrolux EI28BS36IS, EI28BS36IB manual To adjust the flipper mullion