24 Changing the Water and Air Filters
Your refrigerator is equipped with separate water and
air filtering systems. The water filter system filters all the
water used to produce ice. The air filter removes odors
and impurities from the refrigerator compartment.
Push Water Filter Button
NOTE
The control panel includes controls to monitor the
status of your water and air filters. See the Controls
section for more information.

About your advanced water filter

The PureAdvantageTM NGFC-2000 filter
system is tested and certified by NSF
InternationaltoNSF/ANSIStandards
42 and 53 for the reduction of claims
specified on the performance data sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst
reduction may be used on disinfected waters that may
contain filterable cysts.
 • RatedCapacity-240gallons
 • Ratedserviceow-.5gallonsperminute
 • MaximumRatedPressure-100poundsper
square inch
 • RecommendedMinimumOperatingPressure:
30 pounds per square inch
 • OperatingTemp.:Min.33°F,Max.100°F

Water filter

The water filter is located at the lower left side of the
fresh food compartment.
Replacing your PureAdvantageTM water

filter

In general, you should change the water filter every six
(6) months to ensure the highest possible water quality.
The Water Filter Status light on the Touch Panel
prompts you to replace the filter after the 6 month time
period has elasped. The water filter status light on this
model is not performance tested or certified by NSF.
If your refrigerator has not been used for a period of
time (during moving for example), change the filter
before reinstalling the refrigerator.
It is not necessary to turn the water supply off to
change the filter. Be ready to wipe up any small
amounts of water released during the filter replacement.
1 Push the filter release button above the cartridge
to disconnect it.
2 Slide the old water filter cartridge straight out of
the housing and discard it.
3 Unpack the new filter cartridge and remove the
two (2) protective caps covering the inlet and exit
of the filter. Slide the filter gently into the housing
until it stops against the snap-in connector at the
back of the housing.