
TANDBERG 7000 MXP
5.12Digital Monitor Power Management
DMPM is monitor power management applied over the digital DVI interface. TANDBERG supports DMPM in software F2 and above. Six monitor power states are defined.
Monitor On Power state
Transmitter (TANDBERG codec) and receiver (Monitor) are powered and active. This power state is equivalent with the DPMS normal mode.
Intermediate Power state
When the codec goes from active to standby, it turns off the DVI transmitter and the monitor can go from Monitor On
Power state to Intermediate Power state
The monitor can go from Intermediate Power state to
Non-Link Recoverable Off Power State
The monitor can enter
Monitor Power Switch Off Power state
This state can be entered when the power switch on the monitor is toggled to its off position. This state has two
246