3 General Use

Wake up the system

When the system is not in use, it is in standby mode and the screens are black. Wake up the system by picking up the remote control. An incoming call or pressing any key on the remote control will also wake up the system.

If the system does not respond:

ƒMake sure that the system is switched on by using the On/Off switch located at the rear of the Codec.

ƒVerify that your monitor is switched on. This is normally done by pushing the power button on the front of the monitor depending on monitor type

Page 33
Image 33
TANDBERG 700 MXP user manual General Use, Wake up the system, If the system does not respond