Installation
2.1 Unpacking and Mounting
1 Unpacking
The TANDBERG 7000 MXP is delivered in one transport case with all components inside as shown in figure 1:
Foot
Column
Monitor Frame with
Monitor Rear Cover
W.A.V.E. II Camera
Accessories box which will contain the following:
Two Table Microphones
Remote Control and Tracker with batteries
Cables
Documentation
Figure 1
2 Mounting of the base
Place the column with the bolts into the bolt holes on the foot as shown in figure 2. Secure the column and the foot with nuts (nuts and wrench is found in the accessories box) by tipping the base (column/foot) as shown in figure 3. Place the base in an upright position where the system is supposed to stand.
Figure 2 | Figure 3 |
3 Installing the monitor frame
Lift the monitor frame out of the transport case. Do not remove the protective plastic film from the monitor front before the monitor frame is securely fastened to the base.
Place the monitor frame on top of the base. Make sure that the cables from the rear side of the monitor frame do not get stuck between the base and the monitor frame.
11
