Electrolux EILFU21GS manual Door Removal, Ice Maker Installation

8Installation

bubble higher, so that the door closes easily when left halfway open.

Turn

Left To

Raise

Turn
Right To	Plastic
Lower
	Leveling Feet
	Crating
	Screw

Discard The (4) Crating

Screws And Wood Base

WARNING

To allow door to close and seal properly, do not let food packages extend past the front of the shelves.

Door Removal

If door must be removed:

•Unplug the unit

•Gently lay freezer on its back, on a rug or blanket.

•Using a flat-tipped screwdriver, reach underneath the base panel and gently pry loose each retainer tab. Remove base panel. Remove wire from clips on bottom of cabinet.

•Unplug connector by holding the cabinet connector in place and pulling the door connector out.

•Remove the bottom hinge screws.

•Remove the plastic top hinge cover.

•Remove the screws from the top hinge.

•Remove the top hinge from the cabinet.

•Remove the door and bottom hinge from the cabinet.

•To replace door, reverse the above procedures and securely tighten all screws to prevent hinge slippage.

Ice Maker Installation

If your freezer has an automatic ice maker, please refer to the insert in the bond pack that came with your freezer (INSTALLATION-CONNECTING ICE MAKER TO WATER SUPPLY) to correctly hook-up your ice maker.