CARE AND CLEANING
Before cleaning always allow the appliance to cool down before switching off at the electricity supply.
CLEANING MATERIALS
Before using any cleaning materials on your appliance, check that they are suitable and that their use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as they may dull the surface finishes. Harsh abrasives must also be avoided.
CLEANING THE OUTSIDE OF THE APPLIANCE
Do not use abrasive cleaning materials e.g. Hob Brite, Brillo pads or scourers on painted or printed finishes as damage may occur. Regularly wipe over the control panel, doors and appliance sides using a soft cloth and hot soapy water. To prevent streaking finish with a soft cloth.
Stainless Steel cream cleaners are abrasive and should be avoided as they may dull the surface finish. Any spillage on the stainless steel finish must be wiped off immediately.
Do not attempt to remove any of the control knobs from the appliance as this may cause damage and is a safety hazard.
CLEANING THE CONTROL KNOBS AND HANDLES
It is strongly recommended that only hot soapy water is used for cleaning the control knobs and handles.
ANY OTHER CLEANING MATERIALS MAY DULL THE SURFACE FINISH.
REMOVING AND REPLACING THE WIREWORK RUNNERS
1.Remove all shelves and furniture from the oven.
2.Hold the wirework at the bottom, unclip from the cavity side and gently pull towards the centre of the oven.
3.Unhook the runner at the top and remove from the cavity.
4.To replace the runners, hook the wirework side runner into the cavity, slide back and press into place.
Ensure the wirework runners are firmly in position before replacing the oven shelves.
17
SIDE PANEL
CAVITY CENTRE
