Electrolux Electronic Freezer no_frost manual What to do if

		What to do if ...
Malfunction	Possible cause	Remedy
The appliance is over-	The temperature has been	Temporarily select a higher
cooling.	set too low.	temperature setting.
	Temperature is not properly	Please refer to the section
	adjusted.	"Temperature Adjustment".
	Door was open for a long	Only leave the door open
The freezer compartment	time.	as long as necessary.
	Within the last 24 hours a
temperature is insufficient.		Press TURBO/FROSTMATIC
	large quantity of warm
		button.
	foods were loaded.
	Appliance is next to a	Please refer to the section
	source of warmth.	"Installation Location".
Interior illumination does	Light bulb is defective.	Please refer in this chapter
not function.		under "Replace light bulb" .
		Carefully warm the door
		seal with a hand-held hair
		dryer at those points which
Accumulation of frost at	Door is not properly sealed	are not airtight (no warmer
	(perhaps after reversing	than approx. 50°C). At the
the door seal.
	the door).	same time, shape the
		warmed door seal by hand,
		so that it is again properly
		seated.
	Appliance is not level.	Readjust the front levelling
		feet.
	Appliance is in contact	Push appliance away a
Unusual noises.	with wall or other objects.	short distance.
	A part at the back of the
	appliance, e.g. a tube, is in	Bend this part away
	contact with another	carefully if necessary.
	appliance part or the wall.
The compressor does not
start immediately after
pressing the TURBO/	This is normal, no error has	The compressor starts after
FROSTMATIC button, or	occurred.	a period of time.
after changing the
temperature setting.

818 22 86-00/8 31