Electrolux ERB 34001W manual Re-insert the stoppers t, z on the other side of the doors

spacer (b) under the door mount is also removed (Fig. 3).

Lift the freezer door up slightly and remove.

Remove stops in both doors (t, z) (Fig. 5).

Lift out the insert for the lower covering grid (e) using a screw driver (Fig. 4).

Unscrew the bottom door retaining pin for the freezer door (h, f) and then screw in on the other side. Don't forget the spacer (h) (Fig. 4).

Insert the insert for the lower covering grid (e) on the other side.

Fig.4

Remove the left-hand cover pin of the double door mount (3 pieces, n, k) and move to the other side (Fig. 3).

Disassemble the door locking elements (u, v) by unscrewing the screw (s) (Fig. 3).

Reverse the door locking elements (u, v), move to the other side of the other door and fix by screwing in the screw

(s).

Re-insert the stoppers (t, z) on the other side of the doors.

GB electrolux 49

Fig. 5.

Fit the pin of the double door mount

(m)into the left-hand hole of the freezer door (Fig. 3).

Place the freezer door on the lower door retaining pin (f) (Fig. 4).

Open doors and fix the double door mount with 2 screws (c) on the left- hand side. Don't forget the plastic spacer under the door (b) as well. The edges of the doors must run parallel to the side edge of the appliance.

Place the fridge door on the double door retaining pin.

Remove the top left-hand side door mount (f) and the panel (c) from the plastic bag and attach using the screws (c) (Fig. 1).

Open the fridge door, attach the top cover (j) using 2 screws (a); at the same time pay attention to the repositioning of the magnet (k), then close the door (Fig. 2).

Put the appliance into position, make adjustments if not horizontal and connect to the electrical supply.

If you do not want to carry out these steps yourself, please contact the nearest branded service point. Technicians will make a charge for door reversal.