12
VQT1T64
Quick Guide∫Charging the battery
1) Connect the AC cable to the AC adaptor and
the AC outlet.
2) Insert the battery into the battery charger by
aligning the arrows.
∫Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
AInsert the battery until it clicks and locks.
∫How to turn on the power
Turn on the power by turning the mode dial to
or while pressing the lock release
button A.
≥Rotate the mode dial while at the same time
pressing in the lock release button if changing
from OFF to another mode.
≥Status indicator B
≥Align with the mark C.
≥To turn off the power, set the mode dial to OFF.
∫Inserting/removing an SD card
1) Open the LCD monitor.
≥Check that the card access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever B.
3) Insert/remove the SD card.
≥When inserting an SD card, face the label side
C in the direction shown in the illustration and
press it straight in as far as it will go.
≥When removing the SD card, press the center
of the SD card and then pull it straight out.
4) Securely close the SD card cover.
≥Securely close it until it clicks.
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging
completed
Card access lamp [ACCESS] A
≥When this unit is accessing the card, the
access lamp lights up.
HDCSD100P-VQT1T64_ENG.book 12 ページ 2008年7月14日 月曜日 午後8時2分