Panasonic HDC-SD100PC Zoom operation, Manual focus adjustment, Zoom by rotating the ring

Zoom operation

Zoom operation can be done using the multi manual ring.

≥Move the AUTO/MANUAL switch from the MANUAL to FOCUS/ZOOM position, and display

[ ]. (l 69)

Zoom by rotating the ring.

A

B

A side:

Close-up recording (zoom in)

B side:

Wide-angle recording (zoom out)

≥The zoom speed varies depending on the speed to rotate the ring.

≥Auto focus is on when [ ] is displayed.

Manual focus adjustment

If auto focusing is difficult due to the conditions, then use manual focus.

≥Move the AUTO/MANUAL switch from the MANUAL to FOCUS/ZOOM position, and display [MF]. (l 69)

1 (When MF assist function is used)

Select the menu. (l 29)

[ADVANCED] # [MF ASSIST] # [ON]

≥This function’s default setting is [ON].

2 Adjust the focus by rotating the ring.

The center of the screen is enlarged. The normal screen returns approximately 2 seconds after you finish bringing the subject into focus.

≥The center of the screen is not enlarged when [MF ASSIST] is [OFF].

≥To return to auto focus, move the AUTO/ MANUAL switch to FOCUS/ZOOM position

and display [ ], or set to AUTO.

≥MF assist does not work if the zoom magnification is more than 12k.

≥The part of the screen that is enlarged is not enlarged on the image actually recorded.

≥Face detection framing is not displayed when the display is enlarged even if

[FACE FRAMING] is set to [ALL].

≥The zebra pattern does not appear on the part of the screen that is enlarged when [ZEBRA] is [ON].

≥Luminance display is not displayed when the display is enlarged even if [LUMINANCE] is set to [ALWAYS].

≥Histogram is not displayed when the display is enlarged even if [HISTOGRAM] is set to [ALWAYS].

70

VQT1T64