Setup | 2 | Connection and recognition |
|
|
|
After the software applications are installed, this unit must be connected to the PC and be correctly recognized by the PC.
≥Remove the supplied
AUSB cable (supplied)
1 Connect this unit to the AC adaptor.
2 Turn on the unit.
≥This function is available in all modes.
Disconnect the USB cable, before turning this unit off.
≥Do not disconnect the USB cable or the AC adaptor while the card access lamp is on or
card access icon ( 
) appears on the unit screen. Doing so may damage the data.
3 Connect this unit to a PC.
The USB function selection screen will appear.
≥Insert the USB connectors as far as they will go.
≥Do not use any other USB connection cables except the supplied one. (Operation is not guaranteed with any other USB cables.)
4 Select [PC CONNECT] and press the cursor button.
≥This unit is automatically detected by the PC.
≥[AVCHD CONNECT] is for future expansion menu.
≥When the unit is connected to a PC, the operation mode cannot be changed and its power cannot be turned off.
∫If the driver has not been recognized properly
Use the following methods to enable it to be recognized.
Method 1:
Turn off the unit and your PC once and try verifying again.
Method 2:
Remove the SD card and try verifying again.
Method 3:
Try connecting the unit to another USB port on your PC.
∫To disconnect USB cable safely
1Double click the 
( 
) icon in task tray displayed on the PC.
≥Depending on your PC’s settings, this icon may not be displayed.
2Select [USB Mass Storage Device] and click [Stop].
3Verify [MATSHITA
115
VQT1T64
