The appliance must be placed at a location whose ambient temperature corresponds to the climate classification*, for which the appliance is designed.
*See on the rating plate on the inside of the appliance.
The following table shows which ambient temperature is correct for each climate classification.
Climate | for an ambient temperature of | |
classification | ||
| ||
SN | +10°C to +32°C | |
|
| |
N | +16°C to +32°C | |
ST | +18°C to +38°C | |
T | +18°C to +43°C |
Door Reversal
1.Close the appliance and disconnect the appliance from the electricity socket.
2.Remove the ventilation grille. There is a part on the grille that can be removed. Remove and reposition it on the opposite side.
3.Support the appliance on a wooden block when it is laid down. This will make it easier to grip under the appliance when returning to an upright position.
4.On the upper part of the appliance. Remove the hinge pin and replace on the other side.
On the lower part of the appliance. Unscrew the hinge. Move the hinge pin and plastic cover. Secure the hinge on the other side.
Remove any play in the door by adjusting the height of the lower hinge with the supplied spanner. Secure with the
5.Raise the appliance and replace the ventilation grille.
6.Move the handle.
Unscrew the handle and secure it to the other side. Press the supplied plastic plugs into the holes to which the handle was previously fitted.
7.Put the appliance in position. Check that the appliance is level. See the section "Positioning the appliance".
Check that the drain hose at the rear of the appliance discharges into the drip tray.
If the appliance is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the appliance must be at least 230 mm to allow the door to open enough so that the shelves can be removed.
The power plug must be accessible after installation of the appliance.
1 |
2 |
3 |
4 |
6
Electrolux 818 35
11
