Electrolux ERCE90AS user manual Maintenance and cleaning, Glass Surface, Cleaning grease filters

Models: ERCE90AS

1 10
Download 10 pages 12.23 Kb
Page 7
Image 7

electrolux e:line rangehood maintenance and cleaning/changing the halogen lamps 5

Maintenance and cleaning

Changing the halogen lamps

caution

Before maintenance or cleaning is carried out, the canopy rangehood should be disconnected from the main power supply. Ensure that the rangehood is switched off at the wall socket and the plug removed.

External surfaces are susceptible to scratches and abrasions, so please follow the instructions below to ensure the best possible result is achieved without damage.

Stainless Steel Surface

Clean stainless steel surfaces using non-abrasive cleaning products that are specifically for use on stainless steel.

To ensure best results also use an even pressure and follow the grain of the stainless steel. Use of a soft cloth reduces the risk of scratching. If the cloth is wet ensure that a dry soft cloth is used to wipe down the surface again reducing the risk of any surface rust appearing.

Glass Surface

The inlay glass panel can be cleaned using warm soapy water. Ensure the cloth is well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning.

Cleaning grease filters

The mesh filters can be cleaned either by hand or in the dishwasher. After cleaning ensure that the filters are completely dry before refitting.

By hand: Soak in warm water and some washing up liquid. For stubborn grease stains use a soft nylon brush to help remove these stains.

In a dishwasher: Ensure that placement of filters is made so as to no impede the functioning of the spray arm. Washing the filters in a dishwasher may cause discolouration of the filters although it will not affect their performance.

Using a small flat blade screwdriver remove the inner stainless steel ring to obtain access to the halogen globe. When removing the inner ring, do so carefully, as the glass lens could easily fall out of the inner ring. Remove halogen globe, whilst cool, and replace carefully with a new globe. The rangehood takes 2 x 20W, 12 volt halogen globes.

important

When handling globes hold with a cloth or gloves to ensure perspiration does not come in contact with the globe as this can reduce the life of the globe.

Page 7
Image 7
Electrolux ERCE90AS user manual Maintenance and cleaning, Glass Surface, Cleaning grease filters