Model description, Fault code and malfunction

Fault code and malfunction

• digital display shows

The dishwasher does not fill with wa- ter

•digital display shows The dishwasher will not drain

•the drain pump operates continu- ously

•all indicators lights on the control

panel go off

The anti-flood device operates

The programme does not start

electrolux 13

•The water tap is blocked or furred with limescale. Clean the water tap.

•The water tap is closed. Open the water tap.

•The filter in the water inlet hose is blocked. Clean the filter.

•The connection of the water inlet hose is not correct. The hose can be kinked or squashed.

Make sure that the connection is correct.

•There is a blockage in the sink spigot. Clean the sink spigot.

•The connection of the water drain hose is not correct. The hose can be kinked or squashed.

Make sure that the connection is correct.

•Close the water tap and contact your local Service Force Centre.

•The appliance door is not closed. Close the door.

•Mains plug is not connected in. Put in the mains.

•The fuse has blown out in the household fuse box. Replace the fuse.

•Delay start is set.

Cancel the delay start to start the programme immediately.

After the check, switch on the appliance. The			• Product number (PNC)
programme continues from the point of in-			• Serial number (S.N.)
terruption. If the malfunction shows again,			For these data, refer to the rating plate.
contact your Service Force Centre.			Write the necessary data here:
These data are necessary to help you quickly			Model description :
and correctly:			Product number :
• Model (Mod.)			Serial number :

The cleaning results are not satisfactory
The dishes are not clean	• The selected washing programme is not applicable for the type of
		load and soil.
	•	The basket is loaded incorrectly so that water cannot reach all sur-
		faces.
	• Spray arm does not turn freely because of incorrect arrangement of
		the load.
	•	The filters are dirty or not correctly installed.
	•	The quantity of detergent is too little or missing.
Limescales particles on the	•	The salt container is empty.
dishes	• The water softener is adjusted on a wrong level.
	•	The salt container cap is not closed correctly.
The dishes are wet and dull	• No rinse aid has been used.
	• The rinse aid dispenser is empty.
There are streaks, milky spots	• Decrease the rinse aid dosage.
or a bluish coating on glasses
and dishes