Electrolux ESF 66010 user manual Setting manually, Setting electronically, Examples

12electrolux first use

The water softener must be set in both ways: manually, using the water hardness dial and electronically, using some of the programme buttons on the control panel

Setting manually

The dishwasher is factory set at position 2.

1.Open the dishwasher door.

2.Remove the lower basket from the dishwasher.

3.Turn the water hardness dial to position 1 or 2 (see table).

4.Replace the lower basket.

Setting electronically

The dishwasher is factory set at level 5.

1.Press the On/Off button. The dishwasher must be in setting mode.

2.Press simultaneously and keep pressed buttons 2 and 3, until the lights of buttons 1, 2 and 3 start flashing.

3.Press button 1, the lights of buttons 2 and 3 turn off while the light of button 1 goes on flashing. In the digital display is visible the current level.

Examples:

displayed = level 5 displayed = level 10

4.To change the level, press button 1. Each time the button is pressed the level changes. (For the selection of the new level see the chart).

Examples:

if the current level is 5, by pressing button 1 once, level 6 is selected. if the current level is 10, by pressing button 1 once, level 1 is selected.

5.To memorise the operation, switch off the dishwasher by pressing the On/Off button.