something not working | electrolux 29 |
Something not working
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.
Switch off the dishwasher, open the door and carry out the following suggested corrective actions.
Fault code and malfunction
●continuous flashing of the start/cancel indicator light,
●1 flash of the end of programme indicator light,
The dishwasher does not fill with water
●continuous flashing of the start/cancel indicator light,
●2 flashes of the end of programme indicator light,
The dishwasher will not drain
●continuous flashing of the start/cancel indicator light,
●3 flashes of the end of programme indicator light,
Possible cause and solution
●The water tap is blocked or furred with limescale.
Clean the water tap.
●The water tap is turned off. Turn the water tap on.
●The filter (where present) in the threaded hose fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
●The water inlet hose has not been correctly laid or it is bent or squashed. Check the water drain hose connection.
●The sink spigot is blocked. Clean out the sink spigot.
●The water drain hose has not been correctly laid or it is bent or squashed. Check the water drain hose connection.
●Close the water tap and contact your local Service Force Centre.
