Installation
Fitting the outer door
1. Unscrew the screws on the mounting plate. Lift the plate off together with the door.
2.Lay the machine down on its back. Check that none of the hoses are trapped. Insert the guide
rods into the plastic door guides.
3. Slot the tabs on the mounting plate into the holes on the front plinth of the machine and screw the mounting plate into place using the 2 screws provided.
Fitting protective and infill strips
In order to fill the gap between the cupboard and the dish- washer and to protect the cupboard above from any steam that comes out of the washer, a
1. Clean all surfaces where the strips are to be attached to ensure better adhesion.
2.Attach the protective strip along the upper edge of the cupboard. If it is too long, it can easily be
cut to the right length. | Tab |
3. Attach the two infill strips along each side of the cupboard, level with the front edge of the sides.
- 19 -