12electrolux first use
The water softener must be set in both ways: manually, using the water hardness dial and electronically.
Setting manually
The dishwasher is factory set at position 2.
1.Open the dishwasher door.
2.Remove the lower basket from the dishwasher.
3.Turn the water hardness dial to position 1 or 2 (see table).
4.Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1.Press the On/Off button. The dishwasher must be in setting mode.
2.Press and hold the programme selection/cancel button until programme light 1 flashes and programme light 2 illuminates with a fixed light.
3.Wait until:
-programme light 2 turns off,
-programme light 1 goes on flashing
-the end of programme indicator light starts flashing: the nimber of flashes corresponds to the current level set. The flashing is repeated with a pause of a few seconds. Examples: 5 flashes, pause, 5 flashes, pause, etc... =
level 5.
4.To change the level, press the programme selection/cancel button. Each time the button is pressed the level increase. (level 1 follows level10). The end of programme light indicates the new setting.
5.To memorise the operation, switch off the dishwasher by pressing the On/Off button.
