Refit the upper hinge pin into the opposite location. Fit the door in place on the hinge pin.
Slot the hinge pin into the hole in the hinge plate and relocate the hinge assembly to the opposite location and refit using the retaining screws.
Refit the bottom hinge plate assembly on the opposite side, taking care that the edge of the door is parallel with the side of the cabinet.
To reverse the handle proceed as follows:
Remove screw covers (if fitted) and handle retaining screws. Remove blanking plugs on the opposite side.
Relocate the handle to the opposite side and refit retaining screws (covers if fitted), and replace the blanking plugs.
Electrical Connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
This appliance must be earthed.
The manufacturer declines any liability should these safety measures not be observed.
Electrical Requirements
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. Should the plug need to be replaced
15
