TECHNICAL SPECIFICATIONS
POWER SUPPLY VOLTAGE AND FREQUENCY | ||||
TOTAL POWER ABSORBED | 100 W | |||
AVERAGE DAILY UNITS ELECTRICITY(*) | 0,70 kWh | |||
GROSS CAPACITY | 110 l | |||
NET CAPACITY |
| 94 l | ||
STAR RATING |
|
|
|
|
|
|
|
| |
(*)This figure is based on standard test results in accordance with European Standard EN153 (Actual consumption will depend on how the appliance is used and where it is located).
INSTALLATION
Warning
IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.
Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions under “Door reversal”.
Positioning
The appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside left of the appliance. The following table shows which ambient temperature is correct for each climate classification.
SN | +10°C | to | +32°C |
ST | +18°C | to | +38°C |
The appliance should be located in a dry atmosphere, out of direct sunlight and away from continuous heat and extreme temperature, e.g. not next to a boiler or radiator or in a very cold room e.g. an outhouse. If these temperatures are exceeded i.e. warmer or colder, then the appliance may not operate correctly.
For
Important
It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
Door reversal
A
B
D163
The appliance’s door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom.
Attention
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
13
