Recommendations regarding the construction and fitting of a base when the installation requires an integrated appliance to be raised

Where the appliance has been raised by mounting onto a wooden base provided by the installer. The material used to construct the base should have a non slip surface, be water repellent and if possible be one solid piece.

If it is not possible to use one solid piece, due to the additional height required, ensure that any additional strips of timber are glued and screwed to the underside of the base (see Fig. F).

Fix the base firmly to the floor using four appropriate countersunk screws (see Fig. H).

Hardwood strip

5 X 25 X 605

5 mm x 25 mm

490

 

600-605

H

5 mm Hardwood strip

40 mm

100 mm

600-605 mm

Additional pieces of timber should run from front to back

With the appliance installed adjust all four feet ensuring the machine is stable, and a clearance of approximately 5 mm is left between the top of the machine and the underside of the worktop.

F

Front view

A final check for stability should be carried out with the machine on spin with a load, this will identify the need for any further fine adjustment to the feet.

Drill four fixing holes see Fig. G

 

600-605 mm

 

490 mm

 

95 mm

 

Front edge

 

50 mm

G

Top view

 

Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow. The reason for placing the base in this position is to allow a small strip of beading to be fitted in front of the appliance feet.

A strip of beading approximately 605 mm W, x 5 mm H, x 25 mm D must be screwed down into the base directly in front of the machine’s feet, this will provide additional security.

If required an additional door magnet, part number 1242394-00/3 and disc, part number 1242393-00/5 are available from spare parts.

27

Page 27
Image 27
Electrolux EW 1000 I manual Front view