Electrolux EW 1418 1 manual Programme selector dial, End of programme, Interrupting a programme

After the machine has started, only the running phase light illuminate and stay on.

When the programme has finished, the “End” pilot light comes on.

Prewash

Wash

Rinses

Rinse Hold

Drain

Spin

Filter Clogged

End

The “End” pilot light flashes in the event of operating problems and the corresponding alarm code appears on the display..

E10 = the machine does not fill

E20 = the machine does not empty

E40 = the door has not been closed

To eliminate the problem, see paragraph “Something not working”.

If the “Filter clogged” pilot light flashes at the end of the programme this means that the drain filter must be cleaned.

14 Programme selector dial

The selector is divided into the following sections:

•Cotton,

•Synthetics

•Delicates

•Wool

•Handwash

•Special programmes

•Reset programme Off

	Delicate Spin Off	95°	Cotton
	Spin	60°
Drain			E60°
Rinses			60°
Handwash			E40°
			40°
30°			40°-60°Mix
40°			30°
	30°
Delicates	40°	60°
	30°	40°-

Synthetics

The selector dial can be turned either clockwise or anticlockwise.

Positions E60°, E40° and 40°-60°Mix correspond to the ENERGY SAVING programmes and position to “cold wash”.

At the end of the programme the selector dial must be turned to position “Off” (reset).

Functions

End of programme

When the “End” pilot light on the programme progress display illuminates, the door can be opened (if the Rinse hold or Night Cycle option has not been selected).

Turn the programme selector dial to Off.

Switch the machine off by depressing the ON/OFF button before removing the laundry.

Altering an option or a running programme

It is possible to change any option before the programme carries it out.

Before you make any change, you must pause the washing machine by pressing the START PAUSE button.

Changing a running programme is possible only by resetting it. Turn the programme selector dial to "Off" and then to the new programme position.

Start the new programme by depressing the START PAUSE button. The washing water in the tub will not emptied out.

Interrupting a programme

Depress the START PAUSE button to interrupt a programme which is running: the corresponding light starts to flash.

Depress the same button to restart the programme.

Opening the door after the programme has started

You can open the door, after having set the washing machine to PAUSE, provided the following conditions exist:

•the washing machine has not heated beyond 55°C;

•the level of the water is not high;

•the drum is not turning.

If these requirements are met, when you pause the washing machine, the door can be opened.

9