Electrolux EWG 14750 W Permanent connection, Building-in, Preparation and assembly of the door

Note

When the appliance is installed the power supply cable must be accessi- ble.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

Building-in

This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A.

		600
				600
					.
	15	596	70		min
	5		5		820 min
	176,5	0
818	416	12
		1
		54
		8	1
			95
		160
		0
	165	9
		0			A
P0965		49

When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the two recesses on the back of the appliance. This will help to prevent the hoses from becoming kinked or trapped.

installation electrolux 37

Preparation and assembly of the door

The machine is originally pre-arranged for the assembly of a door opening from right to left.

In this case it is sufficient to screw in the hinges (1) and the counter-magnet

(6)provided with the appliance, at the right level (Fig. B).

B
	6		4
	1	7	5
		3
P0982	2

a) Door

The dimensions of the door should be: - width 595-598 mm

- thickness 16-22 mm

The height (C-Fig. C) depends on the height of the adjacent furniture's base.

35 Ø 14 prof.
16		B
-
	22
		416	C
		22+1,5
		-598
		595
P0422			C