Electrolux EWG 14750 W user manual Possible cause Solution, Unsatisfactory washing results

what to do if... electrolux 27

Malfunction

The machine fills then empties immediately:

Possible cause	Solution
● The end of the drain	● Refer to relevant
hose is too low.	paragraph in “water
	drainage” section.

The machine does not empty and/or does not spin:

●The drain hose is squashed or kinked. E20

●The drain pump is clogged. E20

●The Rinse Hold, Night Cycle or No Spin option has been selected.

●Check the drain hose connection.

●Clean the drain pump.

●Select the Drain or Spin programme.

There is water on the floor:

●The laundry is not evenly distributed in the drum.

●Too much detergent or unsuitable detergent (creates too much foam) has been used.

●Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp.

●The drain or inlet hose is damaged.

●The cap on the emergency emptying hose has not been replaced after cleaning the pump.

●Redistribute the laundry.

●Reduce the detergent quantity or use another one.

●Check the water inlet hose connection.

●Replace it with a new one.

●Put the cap back on the emergency emptying hose and place the latter back in its seat.

Unsatisfactory washing results:

●Too little detergent or unsuitable detergent has been used.

●Stubborn stains have not been treated prior to washing.

●The correct temperature was not selected.

●Excessive laundry load.

●Increase the detergent quantity or use another one.

●Use commercial products to treat the stubborn stains.

●Check if you have selected the correct temperature.

●Reduce the laundry load.