Electrolux EWT 106411 W user manual Operating Problems, Drainage Filter Water Inlet Filters

8electrolux

	5	6	7
1	3

2 4 4

DRAINAGE FILTER WATER INLET FILTERS

Clean the filter located at the base of the appliance regularly :

To clean, proceed as follows :

1 2 3

OPERATING PROBLEMS

Numerous checks were carried out on your appliance before it left the factory. Howev- er, should you notice a malfunction, please

refer to the sections below before contact- ing the after-sales service.

Problems

The washing machine doesn’t start or doesn’t fill :

The appliance fills but empties straight away :

The washing machine doesn’t rinse or doesn’t empty :

You have found water around the washing ma- chine :

Causes

•the appliance isn’t plugged in correctly, the electrical installation isn’t working,

•the lid of your appliance and the drum shutters aren’t closed firmly,

•the programme start command hasn’t been properly selected,

•there is a power failure,

•the water supply has been cut off,

•the water inlet tap is closed,

•the water inlet filters are dirty,

•a red tab appears on the water inlet hose1).

•the drainage U-piece is fixed too low (see installation section).

•the drain hose is blocked or bent,

•the drainage filter is obstructed,

•the out of balance detector has been activated : washing is unevenly distributed in the drum,

•the “Drain” programme or “Night Silence Plus” or “Rinse hold” option have been selected,

•the height of the drainage U-piece is unsuitable.

•too much detergent has caused foam to overflow,

•the detergent is unsuitable for machine washing,

•the drainage U-piece isn’t attached correctly,

•the drainage filter hasn’t been put back in place,

•the water inlet hose is leaking.