electrolux 11
After closing the door, it is necessary to se- lect the programme and options again and to press button 8.
AT THE END OF THE PROGRAMME
The machine stops automatically. Three
blinking zeros ( 
) appear on the dis- play.
The pilot light of button 8 goes off. Some acoustic signals sound for a few minutes. If a programme or an option that ends with water left in the tub has been set, the icon
2.8remains displayed to indicate that the water must be emptied out before opening the door.
The drum continues to run at regular inter- vals until the water draining.
Follow the below instructions to empty out the water:
1.Turn the programme selector dial to 
.
2.Select the draining or spinning pro- gramme.
3.Reduce the spin speed if needed, by pressing the relevant button.
4.Press button 8.
At the end of the programme, the icon 2.8 disappears and the door can be opened. Turn the programme selector dial to 
to switch the machine off.
Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.
Stand by : once the programme has finish- ed after a few minutes the energy saving system will be enabled. The brightness of
the display is reduced. By pressing any but- ton the appliance will come out of the ener- gy saving status.
USE - DRYING
DRYING ONLY
Warning!
The recommended load size is 4 kg for cot- tons and linen, 3 kg for synthetic items and 1.5 kg for wool.
Important! For wool items the timed drying is the only drying available (Drying Time button).
By pressing Drying Time button it is also possible to dry up to 6 kg of cot- ton items (see the «Drying Pro- gramme » table).
Warning!
The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe.
1.Load the laundry.
2.Select a spin cycle at the maximum spin speed allowed for the type of laun- dry in order to obtain the best drying performances.
3.Select the drying programme for Cot- tons, Synthetic or Wool in the Drying sector of the programme selector dial.
4.If you wish to select an automatic dry- ing (for cottons and synthetic items on- ly), press the button 5 until the icon corresponding to the required dryness degree appears on the display marked
with the icon | . |
5.If you wish to select a timed drying, press the button 6 until the time you want appears on the display (see the «Drying Programme» table). Every time you press this button the drying time in- creases by 5 minutes.
Note!
The programme time will automatically increase by some minutes.
6.Press button 8 to start the programme. The time remaining is updated every minute.
