Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main
wash compartment 
and, if you wish to carry out a programme with the «prewash» phase, pour it into the compartment marked 
.
If required, pour fabric softener into the
compartment marked 
(the amount used must not exceed the “MAX” mark in the drawer). Close the drawer gently.
Select the required programme
Turn the programme selector dial to the required programme.
The «Start/Pause» light starts to flash and the display shows the duration of the selected programme.
The selector dial is divided into following sections:
| use electrolux 11 |
Drying | Cottons |
Cottons | Normal |
Synthetics | Prewash |
Eco | Synthetics |
Wool | Delicates |
| |
Hand Wash | Easy Iron |
Silk
Spin
Rinse
Drain
●Cottons 
: «Normal» and «+Prewash»
●«Synthetics 
», «Delicates 
» and «Easy Iron 
».
●«Spin 
», «Drain 
» and
«Rinses 
».
●«Silk 
», «Handwash 
», «Wool
» and «Eco 
».
●Drying 
: «Cottons» and «Synthetics»
The selector dial can be turned either clockwise or anticlockwise. Turn to position «O» to Reset programme/ Switch OFF the machine.
At the end of the programme the selector dial must be turned to position «O», to switch the machine off.
Attention!
If you turn the programme selector dial to another programme when the machine is working, the red «Start/Pause» pilot light will flash 3 times and the message Err will appear on the display to indicate a wrong selection. The machine will not perform the new selected programme.
