Something not working electrolux 31
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
During machine operation it is possible that the red «Start/Pause» pilot light flashes, the buzzer sounds and one of the following alarm codes appears on the display to indicate that the machine is not working:
●E10: problem with the water supply
●E20: problem with water draining
●E40: door open.
Once the problem has been eliminated, press the «Start/Pause» button to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
Malfunction | Possible cause | Solution |
The
The machine fills then empties immediately:
The machine does not fill:
●The door has not been closed. E40
●The plug is not properly inserted in the power socket.
●There is no power at the socket.
●The main fuse or the fuse in the plug has blown.
●The selector dial is not correctly positioned and the «Start/Pause» button has not been pressed.
●The «Delay» has been selected.
●The end of the drain hose is too low.
●The water tap is closed.
E10
●The inlet hose is squashed or kinked. E10
●The filter in the inlet hose is blocked. E10
●The door is not properly closed. E40
●Close the door firmly.
●Insert the plug into the power socket.
●Please check your domestic electrical installation.
●Replace the fuse.
●Please turn the selector dial and press the «Start/Pause» button again.
●If the laundry is to be washed immediately, cancel the delay start.
●Refer to relevant paragraph in “water drainage” section.
●Open the water tap.
●Check the inlet hose connection.
●Clean the water inlet hose filter.
●Close the door firmly.
