Electrolux FAVORIT 40650 What to do if, Remedying small malfunctions, first or second rhythm

What to do if...

Remedying small malfunctions

If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault.

After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. The cycle will continue. If the fault is displayed again or if other faults are displayed, please contact your local Service Force Centre and inform them of the fault display.

Malfunction	Possible cause	Remedy
	The tap is blocked or furred	Clean tap.
	with lime-scale.
	The tap is turned off.	Turn the tap on.
	The filter (where present) in	Clean the filter in the
The programme indicator for	the threaded hose fitting on
the selected dishwashing cy-	the tap is blocked.	threaded hose fitting.
cle is flashing,		Press the button for the
the indicator for the end of
		dishwashing cycle that
the dishwashing cycle is
		has started;
flashing in sequence 1 short	Filters in the base of the
		then cancel the dish-
light signal with approx. 3	washing compartment are	washing cycle (see sec-
second pause in-between:
	blocked.	tion: Starting a
(Problems with water inlet)
		dishwashing cycle);
		clean filters (see section:
		Cleaning the filters).
	Water inflow hose has not	Check hose installation.
	been correctly positioned.
The programme indicator for	The sink spigot connection	Clean the sink spigot
the selected dishwashing cy-	is blocked.	outlet.
cle is flashing,
the indicator for the end of
the dishwashing cycle is	Water drain hose has not	Check hose installation.
flashing in sequence 2 short
	been correctly positioned.
light signals one after anoth-
er.

23