Setting electronically:
1.Press the ON/OFF button.
3 If the name of a programme stage is displayed in the display, a dish- washing cycle is active. First of all you must cancel the dishwashing cy- cle:
–Press the RESET button. CONFIRM CANCEL? appears in the display.
–Press the OK/START button. This cancels the dishwashing cycle.
2.Go to the WATER HARDNESS setting; see section “Adapting an option/ setting”.
3.Set WATER HARDNESS to the right setting.
If the water softener is set electronically to “1” this switches off the display of the REFILL SALT message.
| Water hardness |
| Adjusting the hardness setting | ||
in °d1) | in mmol/l2) | Range | Manual | Electronic | |
51 - 70 | 9,0 - 12,5 |
|
| 103) | |
43 - 50 | 7,6 - 8,9 | IV | 1 | 9 | |
37 - 42 | 6,5 - 7,5 | 8 | |||
29 - 36 | 5,1 - 6,4 |
|
| 7 | |
23 - 28 | 4,0 - 5,0 |
|
| 6 | |
19 - 22 | 3,3 - 3,9 | III |
| 5 | |
15 - 18 | 2,6 - 3,2 |
| 4* | ||
|
| ||||
11 - 14 | 1,9 - 2,5 | II | 0* | 3 | |
|
|
|
| ||
4 - 10 | 0,7 - 1,8 | I/II |
| 2 | |
|
|
|
|
| |
below 4 | below 0.7 | I |
| 1 | |
| no salt necessary | ||||
|
|
|
| ||
|
|
|
|
| |
1)(°d) German degree, measure of the hardness of water
2)[mmol/l] millimol per litre, international unit for water hardness
3)On this setting the length of the dishwashing cycle may be slightly longer. *) factory setting
14
