8electrolux
Periods of non-operation
When the appliance is not in use for long pe- riods, take the following precautions:
•disconnect the appliance from elec- tricity supply
•remove all food
•defrost 5)and clean the appliance and all accessories
•leave the door/doors ajar to prevent un- pleasant smells.
If the cabinet will be kept on, ask some- body to check it once in a while to prevent the food inside from spoiling in case of a power failure.
WHAT TO DO IF…
Warning! Before troubleshooting, disconnect the mains plug from the mains socket.
Only a qualified electrician or compe- tent person must do the troubleshoot- ing that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
The appliance does not operate. The lamp does not operate.
The lamp does not work.
Possible cause
The appliance is switched off.
The mains plug is not connected to the mains socket correctly.
The appliance has no power. There is no voltage in the mains socket.
The lamp is in
The lamp is defective.
Solution
Switch on the appliance.
Connect the mains plug to the mains socket correctly.
Connect a different electrical appli- ance to the mains socket. Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
The compressor oper- | The temperature is not set cor- |
ates continually. | rectly. |
| The door is not closed correctly. |
| The door has been opened too |
| frequently. |
| The product temperature is too |
| high. |
|
|
| The room temperature is too |
| high. |
Water flows on the rear | During the automatic defrosting |
plate of the refrigerator. | process, frost defrosts on the |
| rear plate. |
Water flows into the re- | The water outlet is clogged. |
frigerator. |
|
| Products prevent that water |
| flows into the water collector. |
Water flows on the | The melting water outlet does |
ground. | not flow in the evaporative tray |
| above the compressor. |
The temperature in the | The temperature regulator is not |
appliance is too low. | set correctly. |
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than necessary.
Let the product temperature de- crease to room temperature be- fore storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch the rear plate.
Attach the melting water outlet to the evaporative tray.
Set a higher temperature.
5) If foreseen.
