Electrolux FI259/2TA++ user manual Replacing the lamp, Closing the door

Models: FI259/2TA++

1 16
Download 16 pages 12.02 Kb
Page 9
Image 9
Replacing the lamp

Problem

The temperature in the appliance is too high.

The temperature in the re- frigerator is too high.

The temperature in the freezer is too high.

There is too much frost.

Possible cause

The temperature regulator is not set correctly.

The door is not closed correctly.

The product temperature is too high.

Many products are stored at the same time.

There is no cold air circulation in the appliance.

Products are too near to each other.

Food is not wrapped correctly.

The door is not closed correctly.

The temperature regulator is not set correctly.

electrolux 9

Solution

Set a lower temperature.

Refer to "Closing the door".

Let the product temperature de- crease to room temperature be- fore storage.

Store less products at the same time.

Make sure that there is cold air cir- culation in the appliance.

Store products so that there is cold air circulation.

Wrap the food correctly.

Refer to "Closing the door".

Set a higher temperature.

Replacing the lamp

1.Disconnect the mains plug from the mains socket.

2.Remove the screw from the lamp cover.

3.Remove the lamp cover (refer to the illus- tration).

4.Replace the used lamp with a new lamp of the same power and specifically de-

signed for household appliances. (the maximum power is shown on the lamp cover).

5. Install the lamp cover.

6. Tighten the screw to the lamp cover.

7.Connect the mains plug to the mains socket.

8.Open the door. Make sure that the lamp comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "In- stallation".

3. If necessary, replace the defective door gaskets. Contact the Service Center.

Page 9
Image 9
Electrolux FI259/2TA++ user manual Replacing the lamp, Closing the door