Switch off the appliance and carry out the
following suggested corrective actions. Important! If you call out an engineer to a
fault listed below, or to repair a fault caused
by incorrect use or installation, a charge will
be made even if the appliance is under
guarantee.
Fault code and malfunction Possible cause and solution
• appears in the digital display
• Intermittent audible signal
The dishwasher does not fill with
water
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose fitting at
the water inlet valve is blocked.
Clean the filter in the threaded hose.
• The water inlet hose has not been correctly laid or it is
bent or squashed.
Check the water inlet hose connection.
• appears in the digital display
• Intermittent audible signal
The dishwasher will not drain
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid or it is
bent or squashed.
Check the water drain hose connection.
• appears in the digital display
• Intermittent audible signal
Anti-flood device is activated
• Close the water tap and contact our extended warranty
administrators, refer to Repairs-After Sales Service on the
following pages.
Malfunction Possible cause and solution
The programme does not start • The dishwasher door has not been properly closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel the delay
start.
Once these checks have been carried out
switch on the appliance.
The programme will continue from the point
at which it was interrupted.
If the malfunction/fault code reappears or if
other fault codes not described in the charts
appear, please contact our extended
warranty administrators, refer to section
''Repairs - After Sales Service''.
24