5
Please ensure that when the appliance is installed it is easily accessible to an engineer in the event
of a breakdown.
All installations must comply with the local authorities requirements for the discharge of exhaust air.
Incorrect installation may affect the safety of this cooker hood.

Installation Requirements

Before installation check the wall to which the cooker hood is to be fitted for electric cables, water
pipes or gas.
The chimney hood must be installed according to the instructions suppliers below and by qualified and
competent personnel to the relevant National Standards.
This cooker hood is designed to be fixed to any horizontal surface over a cooking area, and can be used in the extraction
(ducted to the outside) or recirculation mode .
The installation work must be undertaken by a qualified and competent person.
The manufacturer disclaims any responsibility for damage due to incorrect installation of the cooker hood or if the
hood is not installed in compliance with relevant regulations controlling this type of installation.
Installation

Unpacking

Before unpacking the cooker hood position the carton
with the arrows pointing upwards as illustrated on the
carton.
The cooker hood is made up of the following compo-
nents:
Ref. Q.ty Product Components
1 1 Hood Body, complete with: Controls, Light,
Blower, Filters
2 1 Telescopic Chimney comprising:
2.1 1 Upper Section
2.2 1 Lower Section
7.1 1 Telescopic frame complete with extractor,
consisting of:
7.1a 1 Upper frame
7.1b 1 Lower frame
9 1 Reducer Flange ø 150-120 mm
10 1 ø120-125 Ducting flange
14 1 Recirculation extension ducting
14.1 2 Recirculation extension ducting
15 1 Recirculation spigot
24 1 Junction box
25 2 Pipe clamps
Ref. Q.ty Installation Components
12c 6 Screws 2,9 x 9,5
12e 2 Screws 2,9 x 6,5
12f 4 Screws M6 x 10
21 1 Drilling template
Q.ty Documentation
1 Instruction Manual
����
���
����
�
���
���
�� ��
���
��
��
��
���
���
����
��
��
���
��
�
�
���